CC  BY -SA 4.0

The Battery Box is a part that fits onto the Top Mount with two to four M3 screws.

The Battery Box takes quite a bit of plastic to print, and I’ll see what I can do to make it print faster in the near future.

Printing Specifications:

  • Time: 2 hours 21 minutes (with 0.3mm layer height) - 4 hours 2 minutes (with 0.15mm layer height)
  • Weight: ~43g
  • Metres of Filament Needed: ~14m
  • Cost of Filament: ~$1.65 CAD (going off an average of $35/kg)
  • Needs Supports: No
  • Needs Raft: No
  • Skirt Recommended: Yes

All content on this site is CC-BY-SA 4.0. Do with it what you will, but link back to this page, and if you publicly-release any content based on this page’s resources, be sure to license that content as CC-BY-SA 4.0, as well.

All resources on this site are provided for informational purposes only. Anything you do because of what you read on this site is at your own risk, and I am not responsible for whatever happens because you accessed this site.

CodeRcar is an open-source project, released AS-IS, with no warranty (expressed or implied).

Have fun; learn something; be safe.

Sincerely, Matthew Piercey - Owner of Bot-In-a-Box Educational Robotics