CC  BY -SA 4.0


The Body part includes mounts for the Raspberry Pi Zero W, four Motors, and two Motor Controllers. The Body also includes structures for placing the Top Mount (which houses the Battery Box and optionally a Breadboard Mount) and two Front Mounts (which can house an Ultrasonic Sensor and an 8x8 LED Matrix).

The Body is the biggest single piece of the kit, and therefore it takes the longest to print.

Printing Specifications:

  • Time: 4 hours, 20 minutes (with 0.3mm layer height) - 8 hours (with 0.15mm layer height)
  • Weight: ~68g
  • Metres of Filament Needed: ~23m
  • Cost of Filament: ~$3 CAD (going off an average of $35/kg)
  • Needs Supports: No
  • Needs Raft: No
  • Skirt Recommended: Yes

All content on this site is CC-BY-SA 4.0. Do with it what you will, but link back to this page, and if you publicly-release any content based on this page’s resources, be sure to license that content as CC-BY-SA 4.0, as well.

All resources on this site https://codercar.botinabox.ca are provided for informational purposes only. Anything you do because of what you read on this site is at your own risk, and I am not responsible for whatever happens because you accessed this site.

CodeRcar is an open-source project, released AS-IS, with no warranty (expressed or implied).

Have fun; learn something; be safe.

Sincerely, Matthew Piercey - Owner of Bot-In-a-Box Educational Robotics