CC  BY -SA 4.0


The Body has two places where Front Mounts can fit on with two M3 screws. Front mounts sit on top of the Motor Controllers, and they allow you to put something like a 8x8 LED Matrix or an Ultrasonic Sensor on top of them.

Printing Specifications:

  • Time: 16 minutes (with 0.3mm layer height) - 30 minutes (with 0.15mm layer height)
  • Weight: ~4g
  • Metres of Filament Needed: ~1.4m
  • Cost of Filament: ~$.25 CAD (going off an average of $35/kg)
  • Needs Supports: No
  • Needs Raft: No
  • Skirt Recommended: Yes

All content on this site is CC-BY-SA 4.0. Do with it what you will, but link back to this page, and if you publicly-release any content based on this page’s resources, be sure to license that content as CC-BY-SA 4.0, as well.

All resources on this site https://codercar.botinabox.ca are provided for informational purposes only. Anything you do because of what you read on this site is at your own risk, and I am not responsible for whatever happens because you accessed this site.

CodeRcar is an open-source project, released AS-IS, with no warranty (expressed or implied).

Have fun; learn something; be safe.

Sincerely, Matthew Piercey - Owner of Bot-In-a-Box Educational Robotics